Updating The Boot Loader Firmware - Ricoh RMY-P1 Field Service Manual

• xxx.brn (Main Firmware)
3. Make a folder on a local drive of your computer and save the files there.
4. Connect a computer and the machine through a network or directly by USB.
5. Click the "FWUpdateTool.exe" file to execute the updating program.
6. Check the information, and then click [OK].
7. For a USB connection, click "F/W Update (USB)" [A]. For a network connection, enter the
machine's IP address in "Machine IP" [B], and then click "F/W Update (NET)" [C].
8. The following message appears on the screen:
"Firmware is Updating ..." and the Alert LED (red) on the printer starts blinking. (The Ready LED
remains lit.)
• Do not turn the main power off from this point until the update procedure is completed.
9. Wait until "FW Update Done. ***Please reboot the Machine. ***" appears in the firmware
update tool window. The Ready LED (green) on the printer starts blinking. (The Alert LED is still
blinking.)
10. Turn off the power of the machine, and then turn it back on.
11. Print a configuration page to check the machine's firmware version.

Updating the Boot Loader Firmware

This is also listed on the configuration page, but this firmware is not updated in the field.
Updating the Firmware
117