Backside; Installation; Set Up And Operation - SHOWTEC Phantom 130 Spot Manual

Hide thumbs Also See for Phantom 130 Spot:
Table of Contents

Advertisement

Phantom 130 Spot

Backside

Fig. 02
03) 100-240V Pro power connector IN
04) 100-240V Pro power connector OUT
05) Ground/earth connection
06) Fuse F5AL/250V
07) 3-pin DMX signal connector IN
08) 3-pin DMX signal connector OUT

Installation

Remove all packing materials from the Phantom 130 Spot. Check if all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
Ordercode: 40073
8

Advertisement

Table of Contents
loading

This manual is also suitable for:

40073

Table of Contents