Built-In Programs Mode; Dmx Mode; Slave Mode; Auto Mode - SHOWTEC Phantom 130 Spot Manual

Phantom 130 Spot

Built-in Programs Mode

You can run the auto programs when using the Phantom.
01) While in the main menu, press the UP/DOWN buttons until the display shows
02) Press the ENTER button to open the menu.
03) Press the UP/DOWN buttons to select one of the 5 modes:

1. DMX Mode

01) When the display shows DMX, press the ENTER button to open the menu.
02) Press the UP/DOWN buttons to toggle between the 2 channel modes:
● 12 channels
● 16 channels
03) Press the ENTER button to confirm your choice.

2. Slave Mode

01) Press the UP/DOWN buttons until the display shows SLAVE.
02) Press the ENTER button to open the menu.
03) Press the UP/DOWN buttons to set the device as the first, second, third or fourth slave device (Slave1-
Slave4).
04) Press the ENTER button to save changes.
05) The device is now operating in the slave mode. It means that it will react the same as the master
device. You can connect up to 4 slave devices to one master device.

3. Auto Mode

01) Press the UP/DOWN buttons until the display shows AUTO.
02) Press the ENTER button to activate the Auto mode.
03) The device will now run the built-in auto show.

4. Sound-controlled Mode

01) Press the UP/DOWN buttons until the display shows SOUND.
02) Press the ENTER button to activate the Sound-controlled mode.
03) The device will now react to the beat of the background music by means of the built-in
microphone.
Ordercode: 40073
15
.