Setting Energy Saver Function; Sleep And Sleep Timer - Olivetti d-COPIA 1801 MF Operation Manual

Installing and Setting up the Machine > Setting Energy Saver Function

Setting Energy Saver Function

To use the Energy Saver function, configure the following settings:
• Sleep and Sleep Timer (page 2-22)
• Power Off Timer (page 2-23)

Sleep and Sleep Timer

Sleep
To enter Sleep, press the
operation panel will go out to save power except the
If print data is received during Sleep, the print job is performed while the message display remains unlit.
To use the machine, press any key on the operation panel.
The machine will be ready to operate within 11 seconds.
Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly.
Sleep Timer
Sleep Timer automatically switches the machine into Sleep if left idle for a preset time.
The default preset time is 1 minute.
To change the preset sleep time, refer to
Follow the steps below to set the sleep timer for the machine to go into sleep mode when not in use.
1
[Energy Saver] key. [Sleeping] is displayed on the message display, and all indicators on the
Sleep Timer on page
Display the screen.
1
Press the [Status/System
2
Press the [▲] or [▼] key to select [Common Settings], and press the [OK] key.
Status/Sys. Menu
Common Settings
[Energy Saver] indicators. This status is referred to as Sleep.
7-12.
Menu/Counter] key.
1
2-22
2