Related Manuals for netvox R718H
Summary of Contents for netvox R718H
- Page 1 R718H Mode： Wireless Pulse Counter Interface Wireless Pulse Counter Interface R718H User Manual...
-
Page 2: Table Of Contents
Table of Content 1. Introduction ................................2 2. Appearance ................................3 3. Main Features ................................3 4.Set up Instruction ..............................4 4.1 Power on and Turn on / off ..........................4 4.2 Join Into LoRa Network ..........................4 4.3 Function Key ..............................4 4.4 Data Report .............................. -
Page 3: Introduction
Introduction R718H is the Wireless Pulse Counter Interface of Netvox ClassA type device based on LoRaWAN open protocol, compatible with LoRaWAN protocol. LoRa Wireless Technology: LoRa is a wireless communication technology dedicated to long distance and low power consumption. Compared with other communication methods, LoRa spread spectrum modulation method greatly increases to expand the communication distance. -
Page 4: Appearance
2. Appearance Fig.1 R718H Appearance 3. Main Features ⚫ Compatible with LoRaWAN ⚫ Detect pulse status ⚫ Simple operation and setting ⚫ External pulse input level is not higher than 3.0V ⚫ 2 ER14505 lithium batteries (3.6V / section) parallel power supply... -
Page 5: Set Up Instruction
The green indicator will stay on for 5 seconds to show it joins into the network, otherwise, the green indicator will be off. (2) If R718H had been joined into a LoRa network, remove and insert the batteries; it will repeat step (1). -
Page 6: Data Report
4.4 Data Report When the device is powered on, it will immediately send a version package report and a report data including the current pulse count and voltage value. The device sends data in the default configuration before any configuration is done. The pulse count is sent according to the maximum and minimum interval, and the count is automatically cleared after transmission;... -
Page 7: Restore To Factory Setting
(B) When it is not in the network → R718H will enter sleeping mode and wake up every 15 seconds to search a network to join in the first two minutes. After two minutes, it will wake up every 15 minutes to request to join the network. -
Page 8: Low Voltage Alarming
7. Low Voltage Alarming The operating voltage threshold is 3.2V. If the battery voltage is lower than 3.2V, R718H will send a low-power warning to the LoRa network. 8. Installation This product comes with waterproof function. When using it, the back of it can be adsorbed on the iron surface, or the two ends can be fixed to the wall with screws. - Page 9 Please take it to the nearest authorized service facility for repair.