Wireless 2-input ma current meter interface (8 pages)
Summary of Contents for netvox R718IJK
Page 1
This document contains proprietary technical information which is the property of NETVOX Technology. It shall be maintained in strict confidence and shall not be disclosed to other parties, in whole or in part, without written permission of NETVOX Technology. The specifications are subject to change without prior notice.
Table of Content 1. Introduction ......................... 2 2. Appearance ........................3 3. Main Features ......................4 4.Set up Instruction ......................5 4.1 Power on and Turn on / off ................. 5 4.2 Join Into LoRa Network ..................5 4.3 Function Key ...................... 5 4.4 Data Report ......................
1. Introduction R718IJK is a multi-sensor interface detection device for Netvox ClassA type devices based on LoRaWAN open protocol. R718IJK multi-sensor interface including 0-24V ADC, Dry Contact and 4-20mA, and R718IJK is compatible with LoRaWAN protocol. LoRa Wireless Technology: LoRa is a wireless communication technology dedicated to long distance and low power consumption.
Applicable to third-party platforms: Actility/ThingPark, TTN, MyDevices/Cayenne Improved power management for longer battery life Note Battery Life*2: Please refer to web: http://www.netvox.com.tw/electric/electric_calc.html At this website, users can find battery life time for varier models at different configurations. 1. Actual range may vary depending on environment.
The green indicator will stay on for 5 seconds to show it joins into the network, otherwise, the green indicator will be off. (2) If R718IJK had been joined into a LoRa network, remove and insert the batteries; it will repeat step (1).
4.4 Data Report The device will immediately send a version packet report along with an uplink packet including 0-24V ADC, Dry Contact and 4-20mA values. The device sends data in the default configuration before any configuration is done. Default value: Maximum time: 900s (15min) Minimum time: 900s (15min) Reportchange:...
Page 9
Example#1 based on MinTime = 1 Hour, MaxTime= 1 Hour, Reportable Change i.e. BatteryVoltageChange=0.1V MaxTime MaxTime leeping(MinTime) leeping(MinTime) Wakes up and collects data Wakes up and collects data REPORTS 3.6V REPORTS 3.5V Note: MaxTime=MinTime. Data will only be report according to MaxTime (MinTime) duration regardless BtteryVoltageChange value.
1. Press and hold function key for 5 seconds till the green indicator flashes and then release; LED flashes quickly 20 times. 2. R718IJK is at off mode by default setting after restoring to factory setting. Note: The device operation of turning off is the same as the “Restore Factory Settings” operation.
(B) When it is not in the network → R718IJK will enter sleeping mode and wake up every 15 seconds to search a network to join in the first two minutes. After two minutes, it will wake up every 15 minutes to request to join the network.
9. Important Maintenance Instruction Your device is a product of superior design and craftsmanship and should be used with care. The following suggestions will help you use the warranty service effectively. • Keep the equipment dry. Rain, moisture, and various liquids or moisture may contain minerals that can corrode electronic circuits.