Battery Charging Information On Display Screens - Miller Bobcat 200 Air Pak Diesel Owner's Manual

8-6. Battery Charging Information On Display Screens

A. Selected Charge Voltage And Output Voltage
CHRG
12V
14.8 25
B. Check Battery
BATT
CHEK
C. Jump Timeout
WAIT
JUMP
D. Battery Bad
BAD
BATT
E. Charge Complete
DONE
BATT
OM-281710 Page 42
.
A complete Parts List is available at www.MillerWelds.com
Several seconds after the battery charger is turned on, the display screens indicate the selected charge
voltage, then switch to show output voltage and amperage at the battery charging receptacle.
Code indicates the battery will not accept a charge, battery voltage does not match charging voltage, or
the system is improperly connected. Check battery and connections. Cycle Charge/Weld switch to restart
charging.
Code indicates the system was drawing too much current for too long of a time during an attempt to jump
start. Charge automatically restarts after cool down time.
The charger has determined that the battery is faulty and is unable to take a charge.
Replace the battery.
The battery charge process has completed successfully.
1
Display screens provide information
on charge mode, charging output,
1
and charging status. Explanations of
the display screen codes are
provided in the tables below.
Display Screens
Ref. 907760