Connecting The Battery; Installing Exhaust Pipe - Miller Bobcat 200 Air Pak Diesel Owner's Manual

5-6. Connecting The Battery

5-7. Installing Exhaust Pipe

Tools Needed:
1/2 in.
.
A complete Parts List is available at www.MillerWelds.com
+
−
Tools Needed:
1/2 in.
!
!
!
.
Install provided pipe and clamp onto
exhaust outlet and tighten.
!
Connect negative (−)
battery cable last.
Open top service door. Connect
battery, negative cable last.
S Do not allow the battery
cables to touch opposing termin-
als. When connecting the battery
cables attach the positive (+)
cable to the positive (+) battery
terminal first, followed by negat-
ive (−) cable to negative (−) bat-
tery terminal.
S Never start the engine when
the cables are loose or poorly
connected to the battery
terminals.
S Never disconnect the bat-
tery while the engine is running.
S Never use a quick battery
charger to start the engine.
S Do not charge battery with
Engine Control switch On.
Always disconnect the neg-
S
ative (−) battery cable before
charging battery.
Ref. 907760 / Ref. S-0756-D / 804 953-B
Stop engine and let cool.
Engine backfire can cause se-
vere burns or other injuries.
Do not point exhaust pipe to-
ward control panel. Keep away
from exhaust outlet.
Do not point exhaust pipe to-
ward any compressed gas
tank.
Point exhaust pipe in desired di-
rection but always away from
control panel and direction of
travel.
804 956-B / Ref. 907760
OM-281710 Page 27