Connecting Or Replacing The Battery; Electronic Fuel Injection (Efi) System And Battery Information - Miller Bobcat 250 Owner's Manual

5-5.

Connecting Or Replacing The Battery

1/2 in.
wrench
crescent wrench
5-6.

Electronic Fuel Injection (EFI) System And Battery Information

NOTICE – EFI system components can be damaged if these precautions are not followed:
� Do not allow the battery cables to touch opposing terminals. When connecting the battery cables attach the positive (+) cable to the positive
(+) battery terminal first, followed by negative (-) cable to negative (-) battery terminal.
� Never start the engine when the cables are loose or poorly connected to the battery terminals.
nutdriver
� Never disconnect the battery while the engine is running.
chippinghammer
� Never use a quick battery charger to start the engine.
� Do not charge battery with Engine Control switch On.
� Always disconnect the negative (-) battery cable before charging battery.
wirecutter frontcutter
�
Complete Parts List is available at www.MillerWelds.com
Complete Parts List available at www.MillerWelds.com
1
250916-A
Connect negative (-) battery cable
last.
To connect battery, open side access doors.
1 Battery Holddown
To change battery, remove rear panel with
baffle and battery holddown.
Be sure battery cables and fuel tank vent
hose are not pinched when installing battery
and replacing rear panel.
OM-249336 Page 7
OM-249336 Page 25