Section 5 − Installation; Installing Unit - Miller Bobcat 200 Air Pak Diesel Owner's Manual

5-1. Installing Unit

Movement / Airflow Clearance
Location / Mounting
1
.
Go to MillerWelds.com for more
information on truck installations.
Movement
!
Do not move or operate unit where
it could tip.
!
Do not lift unit from end.
.
See Section 4-7 for lifting eye rating.
Airflow Clearance
NOTICE − Do not install unit where air flow
is restricted or engine may overheat.
Location/Mounting
!
Always securely fasten unit onto
transport vehicle and comply with
all DOT and other applicable codes.
.
A complete Parts List is available at www.MillerWelds.com
SECTION 5 − INSTALLATION
OR
OR
1
!
Do not weld on base. Welding on
base can cause fuel tank fire or ex-
plosion.
NOTICE − Do not mount unit by supporting
the base only at the four mounting brack-
ets. Do not use flexible mounts. Use cross-
supports to adequately support unit and
prevent damage to base.
1 Cross-Supports (Minimum 3 in.
Wide)
2 Mounting Brackets (Supplied)
NOTICE − If mounting brackets are re-
moved, the bolts must be reinstalled into
the unit.
Mount unit on flat surface or use cross-
supports to support base. Secure unit with
mounting brackets or through internal
holes.
24 in.
(610 mm)
2 in.
(51 mm)
6 in.
(152 mm)
2
Welding Unit In Place
Bolting Unit In Place
3
2
4
Install4_2019−02 − Ref. 907705 / 805454
3 3/8 in. Bolt And Washer (Minimum −
Not Supplied)
4 3/8-16 x 1 in. Screws (Supplied)
To Bolt Unit In Place Using Internal
Pattern:
Remove hardware securing the four
mounting brackets to the base. Discard
brackets and reinstall original hardware.
Mount unit to truck with 3/8 in. (10 mm) or
larger hardware (not supplied).
To Weld Unit In Place:
Remove hardware securing the four
mounting brackets to the base. Reverse
brackets and reattach to base with original
hardware.
Weld unit to vehicle only at the four mount-
ing brackets.
1 in.
(25 mm)
18 in.
(460 mm)
OM-281710 Page 23