Section 8 − Battery Charging; Battery Charging Guidelines; Connecting Uninstalled Battery To Battery Charge Receptacle - Miller Bobcat 200 Air Pak Diesel Owner's Manual

SECTION 8 − BATTERY CHARGING

8-1. Battery Charging Guidelines

!
Stop engine.
!
Before charging battery, read the
Safety Precautions at the begin-
ning of this manual.
!
Have only qualified persons do
battery charging work.
!
Do not charge a defective battery,
a battery with loose terminals, or
one having evidence of damage
such as a cracked case or cover.

8-2. Connecting Uninstalled Battery To Battery Charge Receptacle

Battery located outside of vehicle
1
2
−
!
Stop engine. Place Air Compressor
switch in the Off position.
!
Before charging battery, check po-
larity of battery posts. Attach a 24 in.
(60 cm) AWG 6 insulated battery
cable to Negative (−) battery post.
Connect charger Positive (+) cable
to Positive (+) post of battery. Stand-
ing as far from battery as practical
and looking away from battery, con-
nect charger Negative (−) cable to
.
A complete Parts List is available at www.MillerWelds.com
!
Keep battery charging cables
away from vehicle hood, door, and
moving parts.
!
Do not use damaged battery char-
ging cables.
!
Be sure charger output voltage
matches battery voltage.
3
+
4
7
the cable connected to the Negative
(−) battery post.
1 Battery Positive (+) Terminal
2 Battery Negative (−) Terminal
Obtain Battery Charge/Jumper Cable Kit
300422 or equivalent.
3 Red (Positive) Charging Cable
4 Black (Negative) Charging Cable
5 Battery Charge Plug
6 Battery Charge Receptacle
!
Do not jump-start/crank assist a
vehicle without a battery.
!
Never
crank assist connections or ca-
bles when charging or jumping/
crank assisting. Clamps may be
energized when unit is in battery
charge mode.
!
Never place 12V battery on 24V
only setting.
5
6
7 Insulated Battery Cable
(Customer-Supplied)
Connect a 24 in. (60 cm) or longer insulated
battery cable (AWG 6) to Negative (−) bat-
tery post. Connect red (Positive) battery
charging cable to battery Positive (+) post.
Connect black (Negative) battery charging
cable to insulated battery cable.
Connect Battery Charge plug to Battery
Charge receptacle.
NOTICE − Always connect cables to
battery first, then to Battery Charge recep-
tacle.
disconnect jump-start/
OM-281710 Page 39