Engine Prestart Checks - Miller Bobcat 200 Air Pak Diesel Owner's Manual

5-4. Engine Prestart Checks

.
A complete Parts List is available at www.MillerWelds.com
Check all fluids daily. Engine must be
cold and on a level surface. Unit is
shipped with 10W30 engine oil.
.
Follow run-in procedure in en-
gine manual.
.
This unit has a low oil pressure
shutdown switch.
some conditions may cause en-
gine damage before the engine
shuts down. Check oil level often
and do not use the oil pressure
shutdown system to monitor oil
level.
Fuel
Add fresh fuel before starting engine
the first time (see maintenance label
for specifications). Stop fueling be-
fore reaching the neck. Leave 2 in. of
air space below the neck to allow for
fuel expansion and tilt. Check fuel
level on a cold engine before use
each day.
To check fuel level, turn Engine Con-
trol switch On. Fuel gauge indicates
fuel level in tank.
Engine Oil
NOTICE − Do not exceed the "Full"
mark on the oil level dipstick. Engine
damage may occur if crankcase is
overfilled.
After fueling, check oil with unit on
level surface. If oil is not up to full
mark on dipstick, add oil (see mainte-
nance label).
Use front panel meters to determine
hours until next recommended oil
change. See Section 11-5 for oil
change and maintenance hours re-
set procedure.
.
Keep battery in good condition.
Store battery in warm area.
Use correct grade oil for cold
weather.
Oil Fill
Oil Check
Full
OM-281710 Page 25
However,
Ref. 907759