Miller Bobcat 200 Air Pak Owner's Manual page 68

Trouble
Engine cranks but will not start.
Engine starts but stops immediately.
Engine stopped during normal
operation.
Battery discharges between uses.
Unstable or sluggish engine speeds.
Engine does not return to idle speed.
During operation in near freezing tem-
peratures engine starts and goes to
OM-283762 Page 64
.
A complete Parts List is available at www.MillerWelds.com
Check fuel level.
Check battery voltage.
Check battery connections and tighten if necessary.
Check oil level (see Section 5-4).
Have Factory Authorized Service Agent check low oil pressure shutdown switch.
Have Factory Authorized Service Agent check engine.
Check oil level.
Check and refill crankcase with proper viscosity oil for operating temperature, if necessary.
Check low oil pressure shutdown switch.
Check fuel level.
Replace fuel filter(s) (see Section 11-5).
Check oil level (see Section 5-4).
Check low oil pressure shutdown switch.
Periodically recharge battery (approximately every 3 months).
Replace battery.
Check voltage regulator and connections according to engine manual.
Have Factory Authorized Service Agent check engine.
Clean battery, terminals, and posts with baking soda and water solution; rinse with clear water.
Check voltage regulator and connections according to engine manual.
Periodically recharge battery (approximately every 3 months).
Replace battery.
Check oil level. Oil level should not exceed Full mark on dipstick.
Tune-up engine according to engine manual.
Remove weld, generator power, and air loads.
Have Factory Authorized Service Agent check PC3, current transformer CT1, and Engine Control switch
S2.
Treat fuel with isopropyl alcohol de-icer product.
Remedy