Installation Procedure - Ricoh A-P3 Service Manual

MAILBOX INSTALLATION (G909)

1.10.3 INSTALLATION PROCEDURE

G909I500.WMF
!
CAUTION
Unplug the main machine power cord before starting the following
procedure.
NOTE: If a finisher will be installed, first install this mailbox, then the bridge unit for
the mailbox (G912), and finally install the finisher.
1. Unpack the finisher and remove the pieces of tape.
2. Attach the front joint bracket [A] and rear joint bracket [B] to the main machine
(! x 2 ea.).
3. Peel off the backing of the double-sided tape that is attached to the lower
grounding plate [C].
4. Attach one lower grounding plate to the center of the bottom edge of the paper
tray unit as shown.
[B]
[C]
1-24
6 November, 2001
[A]
G909I559.WMF