Memory All Clear: Sp5801 - Ricoh A-P3 Service Manual

6 November, 2001

5.3.5 MEMORY ALL CLEAR: SP5801

Executing Memory All Clear resets all the settings stored in the NVRAM to their
default settings except the following:
SP7003-1: Electrical total counter value
SP5811-1: Machine serial number
SP5907: Plug & Play Brand Name and Production Name Setting
1. Press ! and " together, hold down for over 5 seconds, release and then
press #(Enter).
2. Press or to display "2.Engine".
! "
3. Press #(Enter).
4. Press or to display "5.Mode" then press #(Enter).
" !
5. Press " or ! to display "Memory Clear" then press #(Enter).
6. With "Clear All" displayed, press #(Enter), then press #(Enter) again to execute.
<Clear All>
Result=OK
Here is a summary of all the settings.
No. Item
01 Clear All
Clear Engine
02
Clear SCS
03
Clear Printer
08
Clear NCS
11
7. After clearing all settings make sure that you perform the following settings:
• Do the laser beam pitch adjustment (SP2109). See section 3.9.5.
• Referring to the SMC Report, re-enter any values, which had been changed
from their factory settings.
• Execute SP3001-2 (ID Sensor Initial Setting).
Initializes all items below.
Initializes all registration settings for engine adjustments and
processing settings.
Initializes default system settings and ROM update
information.
Initializes the printer defaults, the printer SP Bit SW, and
printer CSS counter.
Initializes the system defaults and interface settings (IP
addresses also), SmartNetMonitor for Admin., Web Status
Monitor settings, and the TELNET settings.
5-37
PRINTER ENGINE SERVICE MODE
Function