Remote Control Battery Installation - Ricoh PJ WXC1210 User Manual

Table of Contents

Advertisement

Introduction
Push the clip to
1
release the battery
cover.
To ensure safe operation, please observe the following precautions :
Use AAA/R03 type battery.
Avoid contact with water or liquid.
Do not expose the remote control to moisture or heat.
Do not drop the remote control.
If the battery has leaked in the remote control, carefully wipe the case clean and
install new battery.
Risk of an explosion if battery is replaced by an incorrect type.
Dispose of used battery according to the instructions.
Remove batteries from remote control when not using for extended periods.
The remote control may fail to operate if the infrared remote sensor is exposed to
bright sunlight or fluorescent lighting.
22
English

Remote Control Battery Installation

Install new batteries (AAA/
2
R03). Ensure that you have
the batteries' polarity (+/–)
aligned correctly.
Close the battery cover
3
and press it down until it
clicks into place. Do not mix
different types of batteries or
new and old batteries.

Advertisement

Table of Contents
loading

Table of Contents