Service Program Mode Tables; Feed (Sp1000-00) - Ricoh A-P3 Service Manual

PRINTER ENGINE SERVICE MODE

5.3.1 SERVICE PROGRAM MODE TABLES

Service Table Key
Notation
[range / default / step]
italics
*
DFU
Japan only
(S)
(L)

1. Feed (SP1000-00)

SP1 Mode Number
1001* Sub-Scan Registration
Adjustment
1002* Side-to-Side Registration
01 Tray 1
02 Tray 2
03 Tray 3
04 Tray 4
05 Duplex Tray
06 By-pass Tray
07 LCT
1003* Registration Buckle Adjustment
01 Paper Feed Trays, LCT
02 Duplex Tray
03 By-pass Tray
04 Tray 1
05 By-pass Thick
Example: [–9 ~ +9 / +3.0 / 0.1 mm step]. The setting can be
adjusted in the range ±9, value reset to +3.0 after an NVRAM reset,
and the value can be changed in 0.1 mm steps with each key press.
Comments added for reference.
Value stored in NVRAM. After a RAM reset, this default value
(factory setting) is restored.
Denotes "Design or Factory Use". Do not change this value.
The feature or item is for Japan only. Do not change this value.
Sideways feed direction (LEF)
Lengthwise feed direction (SEF)
Adjusts the printing leading edge registration
using the trimming area pattern (SP2902-03,
No.11).
[+9 ~ –9 / 3.0 / 0.1 mm]
Use #(Enter) to toggle between ± before
entering the value.
Specification: 3 ±2 mm
Adjusts the printing side-to-side (main scan)
registration. Changing this setting adjusts the
printing starting position. These settings should
be adjusted after the optical unit or laser
synchronization detection board is replaced.
Reduce the value to move the image closer to
the operation panel side of the machine.
[–9 ~ +9/ +3.0 mm / 0.1 mm step]
[–9 ~ +9/ +2.0 mm / 0.1 mm/step]
[–9 ~ +9/ +0.0 mm / 0.1 mm/step]
[–9 ~ +9/ +3.0 mm / 0.1 mm/step]
[–9 ~ +9/ +1.5 mm / 0.1 mm/step]
Adjusts the relay clutch timing at registration.
Relay clutch timing determines the amount of
paper buckle at registration. (A "+" setting
causes more buckling.)
[–9 ~ +9 / +0.0 mm (1 mm for 1st Tray Feed) /
0.1 mm step]
5-6
What it means
Function and [Setting]
6 November, 2001