Leaving The Sp Mode - Ricoh A-P3 Service Manual

6 November, 2001
• To change a multiple-digit number setting
Press or
! "
Press #(Enter). A number replaces the cursor.
Press or
! "
Press #(Enter). The number selected on the 2nd line replaces the number
above.
Repeat the procedure to enter numbers for the other digits.
Press #(Escape) to return to the previous level.
• To select an item from a list
The current selection is marked with a large asterisk (*).
Press or
! "
With the item that you want to select displayed on the second line, press
#(Enter). The selected item is marked with an asterisk.
Press #(Escape) to return to the previous level.

Leaving the SP Mode

1. When you are finished with SP selection, press
"2.Engine".
2. Press to display "3.End".
"
3. Press #(Enter) to display "Offline".
4. Press !(On Line) to set the printer online.
NOTE: Powering the printer off and on leaves the SP mode, and returns the
printer online in normal operation mode.
to move the cursor to the digit that you want to change.
to increase or decrease the number.
to display on the 2nd line the item to select.
PRINTER ENGINE SERVICE MODE
(Escape) until you see
5-5