Starting/Stopping The Motors - dji MATRICE 350 RTK User Manual

4. Re-calibrate the aircraft if the Aircraft Rear Indicators blink red.
• If the Aircraft Status Indicators blink red and yellow alternately after the calibration is
complete, it indicates strong interference in the current location. Move the aircraft to a
different location and try again.
• A prompt will appear in DJI Pilot 2 if compass calibration is required before takeoff.
The prompt will disappear after the calibration is complete.
• If the compass calibration is complete, place the aircraft on the ground. If the prompt
appears again in DJI Pilot 2, try moving the aircraft to a different location before re-
calibrating the compass.

Starting/Stopping the Motors

Starting Motors
The Combination Stick Command (CSC) is used to start the motors. Push both sticks to the
bottom inner or outer corners to start the motors. Once the motors start spinning, release both
sticks simultaneously.
Stopping the Motors
There are two ways to stop the motors:
1. When the aircraft has landed, push and hold the throttle stick down until the motors stop.
(Recommended).
2. When the aircraft has landed, conduct the same CSC that was used to start the motors.
Release both sticks once motors stop.
Method 1
If the motor is started unexpected, use CSC to stop motors immediately.
MATRICE 350 RTK User Manual
OR
OR
Method 2
©
2023 DJI All Rights Reserved.
31