Starting/Stopping The Motors - dji MAVIC 3 PRO User Manual

DJI Mavic 3 Pro User Manual
Auto Landing
Use the Auto Landing function:
1. Tap . If conditions are safe for landing, press and hold the button to confirm.
2. Auto landing can be cancelled by tapping .
3. If the Downward Vision System is working normally, Landing Protection will be enabled.
4. Motors will stop automatically after landing.
• Choose the proper place for landing.

Starting/Stopping the Motors

Starting the Motors
Perform the Combination Stick Command (CSC) as shown below to start the motors. Once the
motors start spinning, release both sticks simultaneously.
OR
Stopping the Motors
The motors can be stopped in two ways:
Method 1: When the aircraft has landed, push the throttle stick down and hold until the motors
stop.
Method 2: When the aircraft has landed, perform the same CSC used to start the motors until
the motors stop.
OR
Method 1 Method 2
Stopping the Motors Mid-Flight
Stopping motors mid-flight will cause the aircraft to crash. The motors should only be stopped
mid-flight in an emergency situation such as if the aircraft is involved in a collision, a motor
has stalled, the aircraft is rolling in the air, or the aircraft is out of control and is ascending or
descending very quickly. To stop the motors mid-flight, perform the same CSC that was used to
start the motors for two seconds. The default setting can be changed in DJI Fly.
24
©
2023 DJI All Rights Reserved.