Table of Contents
Advertisement
Auto Takeoff/Auto Return to Home
Auto Takeoff
Use the Auto Takeoff function:
1. Launch DJI Pilot 2 and enter the gimbal camera view.
2. Complete all steps in the pre-flight checklist.
3. Tap
. If conditions are safe for takeoff, press and hold the button to confirm.
4. The aircraft will takeoff and hover approx. 1.2 m (3.9 ft) above the ground.
Auto Return to Home
Use the Auto RTH function:
1. Tap
. If conditions are safe to land, press and hold the button to confirm.
2. Auto RTH can be canceled by tapping
3. If the Downward Vision System is working normally, Landing Protection will be enabled.
4. Motors will stop automatically after landing.
• Choose the proper place for landing.
Starting/Stopping the Motors
Starting the Motors
A Combination Stick Command (CSC) is used to start the motors. Push both sticks to the inner
or outer bottom corners to start the motors. Once the motors start spinning, release both sticks
simultaneously.
Stopping the Motors
The motors can be stopped in two ways:
Method 1: When the aircraft has landed, push the throttle stick down and hold. The motors will
stop after three seconds.
Method 2: When the aircraft has landed, push the throttle stick down, and perform the same
CSC used to start the motors. Release both sticks once the motors have stopped.
1
• If the motor is started unexpected, use CSC to stop motors immediately.
.
2
DJI Inspire 3 User Manual
©
2023 DJI All Rights Reserved.
121
Advertisement
Table of Contents
