Starting/Stopping The Motors; Starting The Motors; Stopping The Motors; Stopping The Motors Mid-Flight - dji Mavic 3 Classic User Manual

Hide thumbs Also See for Mavic 3 Classic:

Table of Contents

DJI Mavic 3 Classic User Manual

Starting/Stopping the Motors

A Combination Stick Command (CSC) is used to start the motors. Push both sticks to the bottom

inner or outer corners to start the motors. Once the motors have started spinning, release both sticks

simultaneously.

There are two methods to stop the motors.

Method 1: When the aircraft has landed, push and hold the left stick down. The motors will stop after

one second.

Method 2: When the aircraft has landed, perform the same CSC that was used to start the motors.

The motors will stop after two seconds. Release both sticks once the motors have stopped.

Method 1

Method 2

• If the motor is started unexpected, use CSC to stop motors immediately.

Stopping motors mid-flight will cause the aircraft to crash. The motors should only be stopped mid-

flight in an emergency situation such as if a collision has occurred or if the aircraft is out of control

and is ascending or descending quickly, rolling in the air, or if a motor has stalled. To stop the

motors mid-flight use the same CSC that was used to start the motors. The default setting can be

changed in DJI Fly.

Table of Contents