Dnm100_Configpoll - ICP DAS USA PISO-DNM100-D User Manual

4.4.40 DNM100_ConfigPoll

escription:
D
This method is used to configure the Poll connection of the specific
MAC ID device. The PISO-DNM100 can get/set the data via the
connection, which connects to the specific slave, according to the
produced / consumed connection path of this slave device. This
configuration data will be saved into EEPROM on the PISO-DNM100.
Syntax:
DWORD DNM100_ConfigPoll (BYTE BoardNo, BYTE DesMACID,
Parameter:
BoardNo: [input] PISO-DNM100 board number (0~15)
DestMACID: [input] The remote slave device's MAC ID (0~63)
DeviceInputLen: [input] The input data length of the slave device.
DeviceOutputLen: [input] The output data length of the slave device.
EPR: [input] The EPR value of the slave device.
Return:
DNM100_NoError (0): OK
DNM100_DriverError (10001): Kernel driver is not opened.
DNM100_ActiveBoardError (10002): This board can not be activated or
DNM100_BoardNumberError (10003): BoardNo exceeds the current
DNM100_TimeOut (10023): The PISO-DNM100 has no response.
Others: Please refer to Table 4.2.2 ~ Table 4.2.9
PISO-DNM100 DeviceNet Master API functions User's Manual (Ver: 1.0)
WORD DeviceInputLen,
WORD DeviceOutputLen,
WORD EPR)
kernel driver can not be found.
scanned total board number.
2008/02/25 101