Information Tray - Triumph Scrambler 1200 XE Owner's Handbook Manual

Motorcycle Stationary - Engine Off
• The ignition is switched ON.
• The engine stop switch is in the
RUN position.
Motorcycle Stationary - Engine Running
• Neutral gear is selected.
Motorcycle in Motion
Within 30 seconds of selecting a riding
mode the rider must carry out the
following simultaneously:
• Close the throttle.
• Make sure that the brakes are not
engaged (allow the motorcycle to
coast).
Note
It is not possible to switch into or out of
Off-Road, Off-Road Pro or Rider modes
whilst the motorcycle is in motion, if the
ABS or TC settings are set to Off-road
or OFF in either of those modes.
In this case, the motorcycle must be
brought to a stop before the riding mode
change can take place.
If a riding mode
completed, the
between the previous riding mode and
the newly selected riding mode until the
change is complete or it is cancelled.
The riding mode selection is now
complete and normal riding can be
resumed.
change is
icon will alternate
General Information

Information Tray

When the motorcycle is in motion,
only attempt to switch between the
information tray modes or reset the
fuel information under the following
conditions:
- At low speed
- In traffic free areas
- On straight and level roads or
surfaces
- In good road and weather conditions.
Failure to observe this important
warning
motorcycle control and an accident.
The information tray appears at the
bottom of the display screen and allows
easy access to different motorcycle
status information.
To view the different information tray
items:
• Push the joystick left/right until the
not
required information tray item is
shown.
Note
To access the information tray, any
warning
acknowledged, see page 36.
The information
following items:
• Warnings
Messages, see page 36
• Contrast, see page 36
• Theme Options, see page 37
• Detail, see page 38
Warning
could lead to
messages must
tray contains
and
loss of
first be
the
Information
35