TOHATSU MFS 40A Owner's Manual page 76

76
INSPECTION AND MAINTENANCE
fire prevention and environment protection
regulations.
1. Drain oil from the engine.
2. Place a rag or towel below the oil fil-
ter to absorb any spilled oil.
3. Unscrew old filter by turning the filter
to counter-clockwise.
4. Clean the mounting base. Apply film
of clean oil to O-ring.
Do not use grease.
Install oil filter and tighten it to specified
torque by using oil filter wrench.
Oil filter torque:
18 N·m (13 ft
ENON00028-A
Note
If a torque-wrench is not available when
you are fitting a oil filter, a good estimate
of the correct torque is 3/4 to 1 a turn past
finger-tight. Have the oil filter adjusted to
the correct torque as soon as possible with
a torque-wrench.
10
1. Oil filter wrench
P/N 3AC-99090-0
P/N 3AC99090M
(US. CANADA Only)
· ·
lb, 1.8 kgf m)
1
ENOF00094-0
1
2
1. Oil filter
2. Fuel filter
ENOM00093-A
Fuel filters and fuel tank cleaning
ENOW00093-1
WARNING
Gasoline and its vapor is very flammable and
can be explosive.
Do not start this procedure while engine
is operating or while engine is hot.
Place fuel filter away from every source of
ignition such as sparks or open flames.
If gasoline is spilled, wipe up immediately
and dispose according to the local regula-
tions.
Install fuel filter with all related parts in
place, or fuel leak could occur, leading to
catching fire or explosion.
Check fuel system regularly for leakage.
Contact authorized dealer for fuel system
services. Services by unqualified person
could lead to engine damage.
Fuel filters are provided inside the fuel
tank and engine.
ENOF00925-1