TOHATSU MFS 40A Owner's Manual page 75

9. Pull the bottom of cowl latch to
unlock, lift and remove the top cowl.
10. Fill the engine through the filler port
wi t h t h e r e c o mm e n d e d oil t o
between the upper and lower limit
mark on the dipstick.
11. Tighten the oil filler cap.
12. Leave the outboard motor for 5 min-
utes and check oil level on the dip-
stick. Add oil if necessary
13. Insert the dipstick to the hole com-
pletely and install the top cowl.
14. Start the engine and idling for 5 minu-
ets, then check for no oil leaks and no
warning indicate.
1
3
1. Filler cap
2. Dipstick
3. Filler port
1. Upper limit (Max.)
2. Lower limit (Min.)
2
ENOF00924-0
1
ENOF00113-0
2
INSPECTION AND MAINTENANCE
ENON00920-0
Note
Use only recommended engine oil (See
page 30).
Oil volume needed for complete oil replacement
With oil filter
replacement
Approximately 2.4 L
(2.5/2.1 US/Imp. qt)
ENOW00925-0
CAUTION
Wipe off engine oil well immediately if spilled
and dispose of it in accordance with local
fire prevention and environment protection
regulations.
ENON00031-0
Note
If any amount of water is found in
engine oil, making it milky white, consult
dealer.
If engine oil is contaminated with fuel,
emitting strong fuel smell, consult
dealer.
Some oil dilution is normal if engine is
idled or trolled for long periods, espe-
cially in cooler water temperatures.
ENOM00092-A
Oil filter replacement
ENOW00091-1
CAUTION
You may be injured due to high engine tem-
peratures if you fill engine oil just after oper-
ation. Engine oil should be changed after the
engine has been cooled.
ENOW00926-0
CAUTION
Wipe off engine oil well immediately if spilled
and dispose of it in accordance with local
75
Without oil filter
replacement
Approximately 2.2 L
(2.3/1.9 US/Imp. qt)
10