Table of Contents
Advertisement
Solution 6000-IP
User Guide
System > Commands >
History Log
This menu allows you to review the last 2000 recorded
history events on your system. The information for each
event may be displayed over a number of pages or screens
depending on the actual event recorded.
When you enter this menu the system will show you the
most recent event first. Once the log reaches the maximum
event capacity each new event will replace the oldest event
in the log in a first in , first out fashion.
To move from one log event to the next use the [] and []
keys or if you know the event number you are looking for
simply enter the number followed by the [OK] key and the
system will display that event.
A left [
] and right [
] arrow may be displayed at the end
of the first line on each log screen. These indicate that the
history log contains more than one page for the current
event. To view these pages use the [] and [] keys.
To review the History Log enter programming mode (PIN
+ MENU) then,
1. Press [MENU] + [7] + [0] + [2].
The keypad will display the most recent event
stored in the history log.
E001 Mon,01Apr 02:00:00
Manual Test Report
Panel 1
E001 Dest= SL-----L
Dest 1 at 01-Apr 02:00:03
2. Use the [] and [] keys scroll between history
events and use the [] and [] keys to view the
pages within the event.
3. Press [OK] or [MENU] to exit.
Some other examples of event in the history log are as
follows:
1)
E202 Sun,01Apr 03:41:45
Disarmed by User
Area 1 Name
Ur1 User 1 Name
E202 Dest= SLL-----
Kp1 Keypad 1 Name
Panel 1
Dest 1 at 01-Apr 03:41:57
34
2)
MENU 7-0-2
The Dest= field displays the various reporting route
information for up to eight different reporting destinations.
Your installer will have configured these during installation.
The following letters will be displayed in the eight
destination locations indicating the status of the report.
The log will also show the actual time a report was sent.
System > Commands >
TimeZone Array
This menu allows you to view the true/false status of all
16 timezones at the same time. The timezone status will
be continuously updated on the display so that real time
status can be seen. The top two rows of the display show
the timezone number, the third row displays the timezone
status.
Enter programming mode (PIN + MENU) then,
1. Press [MENU] + [7] + [0] + [6].
The keypad will display the status of all 16
timezones.
In the example above,
T = TimeZones 01 to 05 are true.
F = TimeZones 09 to 12 are false.
- = TimeZones 06 to 08 and TimeZones 13 to 16 are
3. Press [OK] or press [MENU] to exit.
E405 Sun,01Apr 06:41:45
Burglary Zone Bypassed
Area 1 Name
Zn3 Zone 3 Name
E405 Dest= SLL-----
Ur1 User 1 Name
Panel 1
Dest 1 at 01-Apr 06:41:57
Dest =
S = Sent
L = Logged
P = Pending
F = Failed
A = Aborted
T = TimeZone is True
F = TimeZone is False
- = Not Used
0000000001111111
1234567890123456
TTTTT---FFFF----
Press
OK or MENU
disabled or not used.
Bosch Security Systems 10/22 BLCC615U
MENU 7-0-6
Advertisement
Table of Contents
