Table of Contents
Advertisement
Accessory Installation
Accessories, such as grid louvers, half shields, and lenses, are installed on the front of the fixture
without compromising the integrity of the water-tight seal. Secondary lenses are secured with the trim
ring and can be rotated while they are on the fixture, allowing you to focus the beam precisely.
For detailed information, see the following accessory installation instructions that are packaged with
the accessory.
D40/D60 XTI Grid Louver Installation Guide
•
D40/D60 XTI Half Shield Installation Guide
•
•
D40/D60 XTI Secondary Lens Installation Guide
Trim Ring
Figure-2.2 Trim Ring and secondary lens installation.
WARNING:
Installation on a Permanent Base
Install on a suitable, rigid, permanent base with secured bolts. This can include poured concrete pads
on the ground or a solid structure, such as on top of a concrete wall. For mounting, use the full-sized
template that is included in the installation instructions or download the template at etcconnect.com.
D40/D60 XTI Installation Guide.
See the
Installation on a Pole
A Single fixture or Twin fixture pole mount is used to attach the D40/D60 XTI fixture to a pole. The
Single fixture pole mount fits nominal 2-3/8 inch poles and the twin pole mount fits nominal 4 inch
poles. Both mounts can be rotated for focusing. The twin mount allows you to attach two fixtures side-
by-side on one pole.
D40/D60 XTI Pole Mounts Installation Guide.
See the
Installation on a Wall
The Wall Mount Bracket accessory for the D40/D60 XTI fixture provides a stable mounting position for
the fixture, while providing a wire way for a clean and functional installation to walls and other vertical
surfaces.
D40/D60 XTI Wall Mount Installation Guide.
See the
Installation
Make sure all accessories are securely in position before installing the fixture.
17
Advertisement
Table of Contents
