ETC Desire XTI Series User Manual page 20

Safety Cable
The safety cable (or other approved safety device) should be attached to the fixture housing and
wrapped around the hanging structure (pipe). An appropriate attachment loop is provided on the
protruding tab of the fixture housing. Take care to leave as little slack as possible in the safety cable to
avoid the cable catching the yoke of the fixture.
Focus Adjustment
The fixture can be tilted up and down to focus the light where it is needed. Upon powering the fixture,
all colors are automatically on so you can focus the fixture. This preset remains active until it is changed
with an RDM configuration tool or DMX/RDM lighting control device.
Adjusting the Tilt
1. Loosen the yoke locking bolt.
2. With the fixture turned on, tilt it to the desired angle.
3. Tighten the yoke locking bolt.
Adjusting the Pan
The pan is adjusted at the hanging clamp or the mounting base. Consult the clamp manufacturer's
documentation for instructions on loosening and rotating the yoke at the clamp or see the appropriate
installation instructions.
WARNING:
16
Safety
cable loop
The safety cable (or other approved safety device) must be securely attached
to the safety cable loop before loosening the clamp.
Desire D40/D60 XTI v1.8.2 User Manual