Using Event Input; Setting Event Input; Using Multiple Set Points - Omron E5EZ-PRR User Manual

4.4

Using Event Input

■ Setting Event
Input
■ Using Multiple
Set Points
● Using Event
Input With
Multiple
Run/stop control and Auto/Manual selection can be done with event input
assignment 1 and 2.
The following table shows "number of multi set points used ", it gives event input
1 and 2 function assignment.
When 2 or 4 multiple set points are used, use the "number of multi-set points
used" parameter, which determines whether or not "event input assignment 1"
and "event input assignment 2" are displayed.
No. of
Multi-SP
Event Input
Used
Assignment 1
NONE or STOP or MANU "1"
0
- (Not
1
displayed)
2 - (not displayed)
*1 Only when using event input indicators 1 or 2 , the
Auto/Manual can be set.
" "
Once STOP is assigned to one event input, the other side is set to
" "
MANU .
When setting two external input set points, the "number of multi-SP used"
parameter may be set to:
●
select set point (0/1)
When "number of multi-SP used" is set to "1" (initial value) , two set points
may be selected. This setting may not be changed. Set point 0 or 1 is
indicated by the event input 1 status.
"Multiple set points" is a presetting set points 0 through 3 function . It uses both
input event 1 and 2 to select set points.
When using E5EZ-PRR2B □ , and the "number of multi-SP used" is set to "1" or
"2", multiple set points can be used.
●
when "multi-SP used" is set to "1"
Event Input 1
OFF
ON
●
When "multi-SP used" is set to "2"
Event Input 1
OFF
ON
OFF
ON
*Event input the E5EZ-PRR2B □ model. Event input ON/OFF should be used when
the power is on. It can distinguish 50ms or more of input ON/OFF.
Setting
Event Input Event Input 1
Assignment 2
none or Switching RUN/STOP or
NONE or STOP multi set points
or MANU (alternate set
Select Set Point
set point 0
set point 1
Event Input 2
OFF
OFF
ON
ON

4.4 Using Event Input

Event Input Function
Event Input 2
Function Function
Switching Auto/Manual "1"
2 set points No or Switching
RUN/STOP or
Switching Auto/
point 0/1) Manual
4 set points multi set point
(alternate set point 0/1/2/3)
"
stop (run/stop) switching
" "
NONE
Select Set Point
set point 0
set point 1
set point 2
set point 3
"
and
or
4-11