Menu Bar - Sanyo PLC-XK3010 Owner's Manual

Basic Operation
For detailed functions of each menu, see "Menu Tree" on pages 67-68.
Main Menu
①
②
③
④
⑤
⑥
⑦
⑧
⑨
⑩
① Input
Used to select an input source from Computer 1, Computer 2 or Video (pp.7, 36-37).
② PC adjust
Select Auto PC adj., Fine sync, Total dots, Horizontal, Vertical, Current mode, Clamp, Display area-
H and Display area-V to adjust the parameters to match with the PC input signal format (pp.9-31).
③ Image select
Used to select an image mode from among Dynamic, Standard, Real, Cinema, Blackboard(Green),
Colorboard and Image 1-4. (pp.3, 39)
④ Image adjust
For computer source, used to adjust computer image [Contrast, Brightness, Iris, Color temp ., White
balance (R/G/B), Sharpness, Gamma, Reset and Store] (p.33).
For Video source, used to adjust picture image [Contrast, Brightness, Color, Tint, Iris, Color temp .,
White balance (R/G/B), Sharpness, Gamma, Noise reduction, Progressive, Reset and Store] (pp.40-
41).
⑤ Screen
For computer source, used to adjust size of the image [ Normal, Full, Wide(16:9), Zoom, True, Custom,
Custom adj., Digital zoom +/– , Keystone, Ceiling, Rear and Reset] (pp.34-35).
For Video source, used to set size of image [Normal, Full, Wide(16:9), Zoom, Custom, Custom adj.,
Keystone, Ceiling, Rear and Reset] (pp.4-43).
⑥ Sound
Used to adjust the volume or mute the sound or set configurations to the MIC functions (p.4).
⑦ Setting
Used to set the projector's operating configurations (pp.44-56).
⑧ Information
Display the input source information: Input , H-sync freq., V-sync freq., Screen, Language, Lamp
status, Lamp counter , Power management, Key lock, PIN code lock, Remote control and SERIAL
NO .. (p.57)
⑨ Network
See owner's manual of "Network Set-up and Operation".
⑩ Guide
The key operation is displayed.


Menu Bar

Sub-Menu