Sanyo PLC-XK3010 Owner's Manual page 52

Setting
Lamp control
This function allows you to change brightness of the
screen.
High ........... Brighter than the Normal mode.
Normal . ...... Normal brightness
Eco ............ Lower brightness reduces the lamp
power consumption and extends the
lamp life.
Note:

• Lamp mode can not be changed for a while
after turning on the projector. Lamp needs
some time to stabilize after the power is
turned on. Stored lamp mode will be active
after the lamp is stabilized.
Remote control
This projector provides two different remote control
codes: the factory-set initial code (Code 1) and the
secondary code (Code 2). This switching function
prevents remote control interference when operating
several projectors or video equipment at the same time.
When operating the projector in Code 2, both the
projector and the remote control must be switched to
Code 2.
To change the code for the projector:
Select either Code 1 or Code 2 in this Setting Menu.
To change the code for the remote control:
Press and hold both the MENU and IMAGE buttons
together for 5 seconds or more. After changing the code,
make sure the remote control operates properly.
Note:

• When different codes are set on the projector
and on the remote control, any operation
cannot be made. In that case, switch the
code on the remote control to fit the code on
the projector.
• If the batteries are removed from the remote
control for a long period of time, the remote
control code will be reset.
5
Remote control