Sanyo PLC-XK3010 Owner's Manual page 64

Appendix
No image
monitor output when connecting to a projector. See your
Press the NO SHOW button or any other button on the
No sound
speaker is not available.
The color is strange.
Some displays are not seen
during the operation.
Auto PC adjustment function
does not work . work when 480p, 575p, 720p, 480i, 575i, 1035i or 1080i is
The setting does not remain
after turning off power.
Power management does not
work .
Capture function does – Check the connection and the input signal to see if there is
not work .
Auto setup does not
work properly.
Auto keystone function does not – Make sure the Auto keystone function is not set to Manual.
work even when the projector is Press the AUTO SETUP button on the top control. See
tipped .
64
– Check the connection between your computer or video
equipment and the projector. See pages 14-16.
– See if the input signal is correctly output from your computer.
Some laptop computers may need to change the setting for
computer's instruction manual for the setting.
– It takes about 30 seconds to display an image after turning on
the projector. See page 18.
– C heck the Input signal, color system, video system or computer
system mode.
– Make sure the temperature is not out of the specified Operating
Temperature (41˚F–95˚F [5˚C–35˚C]).
– When No Show is operating, the image cannot be displayed.
remote control.
– Check the audio cable connection from audio input source.
– Adjust the audio source.
– Press the Volume + button. See page 4.
– Press the Mute button. See page 4.
– When the AUDIO OUT is plugged-in, the projector's built-in
– Is the image projected? You will hear the Computer and Video
sound only when the image is projected.
– Check the Input signal, color system,video system or computer
system mode.
– Make sure the Blackboard is not selected on Image select
menu. See pages 3, 39.
– Check the Display function. See page 46.
– Check the Input signal. Auto PC adjustment function can not
selected. See page 9.
– Make sure you selected Store after adjusting setting. Some
settings can not be stored if not registered with Store. See
pages 33, 41.
– Power management function can not work while Freeze or No
Show function is running. See page 49.
signal.
– Make sure Off is not selected at any function of Auto setup.
See page 45.
– Make sure On is not selected at the Ceiling function.
See pages 35, 43.
pages 3, 45.