Basic Operation; Turning On The Projector - Sanyo PLC-XK3010 Owner's Manual

1
Complete peripheral connections (with a computer,
VCR, etc.) before turning on the projector.
2
Connect the projector's AC power cord into an AC
outlet. The POWER indicator lights red. Open the
lens cap.
3
Press the ON/STAND-BY button on the top control
or on the remote control. The POWER indicator
lights green and the cooling fans start to operate.
The preparation display appears on the screen and
the countdown starts.
4
After the countdown, the input source that was
selected the last time and the lamp control status
icon (see page 5) appear on the screen.
5
If there is no signal input when start on the projector,
or the current signal is missed while operating the
projector, the Video/PC selection window will be
displayed on the screen, please move the pointer to
input source desired by pressing the Point ▲▼
buttons and press the SELECT button. And then
follow the input signal guidance window to correct
the signal and connection.
If the projector is locked with a PIN code, PIN code
input dialog box will appear. Enter the PIN code as
instructed on the next page.
Note:
• When the Logo select function is set to Off,
the logo will not be shown on the screen
(p.46).
• When Countdown off or Off is selected in
the Display function, the preparation display
will not be shown on the screen (p.46).
• When the Input Search function is set to
On 2, the input signal will be searched
automatically (p.45).
• When Off is selected in the Display function,
the Video/PC selection window and the input
signal guidance window are not shown on
the screen. (p.46)
18

Basic Operation

Turning On the Projector
Open the Open the
The preparation display will disappear after 30 seconds.
Selected Input Source and Lamp Control
Video
(See page 5 for Lamp control status.)
Note:

Video / PC selection window
Input signal guidance window
Current Input setting:Video
Is signal processed correctly?
Is cable connected properly?
Video / PC selection window
Input signal guidance window
Current Input setting:RGB
Is signal processed correctly?
Is cable connected properly?
16
Lamp control status
The Filter warning and Lamp replacement
icons may appear on the screen depending
on the usage state of the projector.
Project Video
Project Video
Project Computer
Cancel
No signal
Project Video
Project Computer Project Computer
Cancel
No signal