Replacing The Filter; Resetting The Filter Counter - Sanyo PLC-XK3010 Owner's Manual

Filter prevents dust from accumulating on the optical elements inside the projector. Should the Filter become
clogged with dust particles, it will reduce cooling fans' effectiveness and may result in internal heat buildup
and adversely affect the life of the projector. If a "Filter warning" icon appears on the screen, replace the Filter
immediately. Replace the filter by following the steps below.
1
Turn off the projector, and unplug the AC power
cord from the AC outlet.
2 Put you finger on the latch's  mark, pull it the
unlock position and remove.
3
Put the new one back into the position.
Put you finger on the latch's  mark, pull it the
lock position to lock.
4
Connect the AC power cord to the projector and
turn on the projector.
5
Reset the filter counter.
CAUTION
- Do not operate the projector with the filters
removed. Dust may accumulate on the optical
elements degrading picture quality.
- Do not put anything into the air vents. Doing so
may result in malfunction of the projector.
- Do not wash the filter with water or any other
liquid Matter. Otherwise the filter may be
damaged.
RECOMMENDATION
We recommend avoiding dusty/smoky
environments when you operate the
projector. Usage in these environments
may cause poor image quality.
When using the projector under dusty or smoky
conditions, dust may accumulate on a lens,
LCD panels, or optical elements inside the
projector degrading the quality of a projected
image. When the symptoms above are
noticed, contact your authorized dealer or
service center for proper cleaning.
Resetting the Filter Counter
Be sure to reset the Filter counter after cleaning or
replacing the filters.
1
Press the MENU button to display the On-
Screen Menu. Use the Point ▲▼ buttons to
select Setting and then press the Point ► or the
SELECT button.
2
Use the Point ▲▼ buttons to select Filter
counter and then press the Point ► or the
SELECT button. Use the Point ▲▼buttons to
select Filter counter reset and then press the
SELECT button. Filter counter Reset? appears.
Select Yes to continue.
3
Another confirmation dialog box appears, select
Yes to reset the Filter counter.
Maintenance and Cleaning
Replacing the Filter
Filter counter reset
Filter
Lock
Note:
• When replacing the filter,
it is required a certain
space to pull out the filter
completely.
Unlock
• When installing the
projector, install the
projector with keeping a
certain space for replacing
the filter.
Filter counter
Reset? appears.
Select Yes, then
another confirmation
box appears.
Select Yes again
to reset the Filter
counter.
Latch
59