Care & Maintenance - Procom EDP200T2-JA Manual

CARE AND MAINTENANCE
WARNING: Failure to keep primary air openings of burners clean may result in sooting and property damage.
CAUTION: You must keep control areas, burner, and circulating air passageways of heater clean. Inspect these areas of
heater before each use. Have heater inspected yearly by a qualified service person. Heater may need more frequent cleaning
due to excessive lint from carpeting, bedding material, pet hair, etc.
The primary air inlet holes allow the proper amount of air to mix with the gas. This provides a clean burning flame. Keep these
holes clear of dust, dirt, and lint. Clean these air inlet holes prior to each heating season. Blocked air holes will create soot. We
recommend that you clean the unit every 2500 hours of operation or every three months.
MAIN BURNER
Periodically inspect all burner flame holes with the heater running. All slotted burner flame holes should be open with yellow
flame present. All round burner flame holes should be open with a small blue flame present. Some burner flame holes may
become blocked by debris or rust, with no flame present. If so, turn off heater and let cool, either remove blockage or replace
burner. Blocked burner flame holes will create soot.
CLEANING BURNER INJECTOR HOLDER AND PILOT AIR INLET HOLE
We recommend that you clean the unit every three months or after 2500 hours of operation. We also recommend that you keep
the burner tube and pilot assembly clean and free of dust and dirt. To clean these parts we recommend using compressed air
no greater than 30 PSI. You can use a vacuum cleaner in the blow position. If using compressed air in a can, please follow the
directions on the can. If you don't follow directions on the can, you could damage the pilot assembly.
1. Shut off the unit, including the pilot. Allow the unit to cool for
at least thirty minutes.
2. Inspect burner, pilot, and primary air inlet holes on injector
holder for dust and dirt (see Fig. 20).
3. Blow air through the ports/slots and holes in the burner.
4. Check the injector holder located at the end of the burner
tube again. Remove any large particles of dust, dirt, lint, or
pet hair with a soft cloth or vacuum cleaner nozzle.
5. Blow air into the primary air holes on the injector holder.
6. In case any large clumps of dust have now been pushed
into the burner. Repeat steps 3 and 4. Clean the pilot
assembly also.
CLEANING ODS/PILOT
Use a vacuum cleaner, pressurized air, or a small, soft bristled brush to clean.
A yellow tip on the pilot flame indicates dust and dirt in the pilot assembly. There is a small pilot air inlet hole about two inches
from where the pilot flame comes out of the pilot assembly (see Fig. 21). With the unit off, lightly blow air through the air inlet hole.
You may blow through a drinking straw if compressed air is not available
CABINET
Air Passageways
● Use a vacuum cleaner or pressurized air to clean the
cabinet to remove dust.
Exterior
● Use a soft cloth dampened with a mild soap and water
mixture.
● Wipe the cabinet to remove dust.
LOGS
● If you remove logs for cleaning, refer to Installing Logs to
properly replace logs.
● Replace log(s) if broken or chipped (dime-size or larger).
BLOWER (Optional Accessory)
Refer to blower manual.
Fig. 20 - Injector holder on
Burner
tube
Primary Air
Inlet Holes
NG Pilot Air Inlet Hole
Pilot Assembly
20
Injector
Fig. 21
LP Pilot Air Inlet Hole