ICP DAS USA ECAN-240-FD User Manual page 31

Item
IP Address
Address Type
Static IP Address
Subnet Mask
Default Gateway
MAC Address
Modbus Settings
Modbus Net ID
Command Port
Command Port
Timeout
(Socket Watchdog)
Update Settings
ECAN-240-FD (Modbus TCP to 2-port CAN FD Gateway) User Manual
Copyright © 2022 ICP DAS Co., Ltd. All Rights Reserved
Static IP: If no DHCP server is installed on the network, the network
settings can be configured manually. Refer to
Configuration for more details.
DHCP: The Dynamic Host Configuration Protocol (DHCP) is a
network application protocol that automatically assigns an IP address
to each device. Refer to
more details.
Each ECAN-240-FD connected to the network must have its own
unique IP address. This parameter is used to assign a specific IP
address.
This parameter is used to assign the subnet mask for the
ECAN-240-FD device. The subnet mask indicates which portion of the
IP address is used to identify the local network or subnet.
This parameter is used to assign the subnet mask for the
ECAN-240-FD device. The subnet mask indicates which portion of the
IP address is used to identify the local network or subnet.
This parameter is used to set a user-defined MAC address, which
must be in the format FF-FF-FF-FF-FF-FF.
This parameter is used to configure the Modbus NetID.of this module
Default value: 1
This parameter is used to configure the Modbus TCP Command Port
to a custom value depending on your requirement.
The default Modbus TCP Command Port is 502
If the command port does not receive any data from the TCP/IP
socket for a certain period, the ECAN-240-FD can disconnect the
socket.
Settings range value: 1 ~ 65535 (seconds);
Default value: 180 (seconds); Disabled: 0;
Click this button to save the revised settings to the ECAN-240-FD.
All settings will take effect after rebooting the device.
Description
Section 4.4.1.2 Dynamic Configuration
Version 1.0.0
E-mail: service@icpdas.com
Section 4.4.1.1 Manual
Page：
for
31