Setup; General Information; Adjustment Elements - Vega VEGACAP 65 Operating Instructions Manual

Function/Configuration
VEGACAP 65 • Two-wire
6

Setup

6.1

General information

The figures in brackets refer to the following illustrations.
On the electronics module you will find the following display and

adjustment elements:

•
DIL switch for measuring range selection
•
Control lamp
Note:
As a rule, always set the mode with the mode switch of the signal
conditioning instrument before starting setup VEGACAP 65. The
switching output will change if you set the mode switch afterwards.
This could possibly trigger other connected instruments or devices.
6.2 Adjustment elements
4
3
Fig. 14: Electronics module - Two-wire output
1 DIL switch for measuring range selection (with compensation button)
2 Ground terminal
3 Connection terminals
4 Control lamp
A failure can be displayed when the housing is closed (only plastic
housing).
Take note of the switching point adjustment of the operating
instructions of the " Controller".
Note:
Screw the housing cover tightly up to the thread stop so that the
inspection glass is above the control lamp (LED).
To adjust VEGACAP 65, first of all remove the housing cover.
6 Setup
1
2
21