Installation - Hanseatic HGTI6082D137709HS User Manual

Page EN-30
Make sure that the appliance is con-
nected to a water supply with a safety
device that prevents drinking water
from being contaminated by backflow (ac-
cording to DIN EN 1717). Connection valves
intended for this purpose must be installed
in a suitable place in a correctly installed
drinking water system in the house. If you
are unsure, consult a qualified professional.
Inlet hose
For water supply, you need a water tap with
a ¾-inch screw connector.
1. Screw the safety valve's lock nut to the
tap hand-tight.
2. Check that the connection to the water
tap is sealed. Turn on the water tap
slowly and ensure that no water is es-
caping. Then close the valve again.
¾ inch
Installation, connection and starting-up

Installation

NOTICE
Risk of damage to property!
By selecting incorrect screws, you may
damage adjacent kitchen units.
■ Use the screws which are supplied in
the delivery or screws of an appropri-
ate length.
(c)
1. To protect the worktop against conden-
sation, affix the enclosed protective film
(c) to the underside of the worktop. This
will help you minimise damage to the
worktop from the outflow of hot steam.
(g)
2. Insert the two mounting brackets (g)
into the front slots on the top of the dish-
washer so that you can screw the dish-
washer to the worktop subsequently.