Problems With Operation - Hanseatic HGTI6082D137709HS User Manual

Troubleshooting table

Problems with operation

Problem
The dishwasher
cannot be switched
on.
The selected dish-
washing programme
will not start or it
stops.
The display will
light up although
dishwasher salt has
been added.
The water is not
running or it is
running only very
slowly.
The water is not
running off or only
very slowly.
The dishwasher is
not watertight.
The dishwasher
can be switched on/
off, but not cannot
be operated.
Possible cause
The mains plug has not been
inserted into a socket.
There is no voltage being sup-
plied through the socket.
The dishwasher's door is not
closed properly.
The water tap is not properly
on.
The inlet hose is defective.
There is a risk of overflowing.
The electrical water stop sys-
tem has been activated.
The dishwasher salt is clumpy. Stir the dishwasher salt using the end
There is a kink in the inlet
hose.
The water tap is not properly
on.
The filters are blocked.
The outlet hose is kinked, has
been extended or is hanging
too high up/too low.
The door seal is defective.
The outlet hose or the inlet
hose is defective.
The dishwasher can only be
operated when the appliance
door is closed.
Solution
Insert the mains plug into the socket.
Check the fuse. Check the socket by
connecting another device.
Close the dishwasher door.
Turn the water tap on completely.
Contact our Service department (see
page EN-40).
of a spoon or similar.
Arrange the inlet hose properly so that
it is not kinked (please see page EN-29).
Turn the water tap on completely.
Clean the filters (see „Checking and
cleaning the filters" on page EN-26).
Lay out the outlet hose in a proper
manner (see page EN-29).
Have the door seal replaced (see
„Service" on page EN-40).
Have the defective hose replaced (see
„Service" on page EN-40).
Close the appliance door.
Page EN-37