Adjusting the Chains
The bike is equipped with an automatic chain tension system, which helps to limit dealer
maintenance. There are two chains that still need to be manually adjusted; the crank chain
and the right middle chain combination with freehub function.
To tension the crank chain, follow these steps:
1.
First loosen the Allen bolt [A].
2.
Use the two holes [B] next to the Allen
bolt to turn the eccentric bracket with a
pin wrench [C].
3.
Turn right to increase chain tension and
left to decrease chain tension.
4.
Once the correct chain tension is achieved,
tighten the Allen bolt [A] again (12 Nm).
To turn the pin wrench on the eccentric bracket,
make sure the pins of the wrench are not thicker
than 4 mm.
Version 23.05
[A]
[B]
[C]
47/59