Van Raam Fun2Go 2 User Manual page 23

Charging the battery
To charge the battery:
1. Unlock the battery by turning the key a
quarter turn.
2. Press the lock in and simultaneously pull the
battery pack out of the holder with your
other hand.
3. Take the battery with you inside. First plug the
charger into the power outlet. The green LED
will light up. The charger is now on stand-by.
4. Then plug the charging connector of the charger
into the charging point of the battery. The red
LED will light up. The charger is now charging.
Caution! If the battery is not properly
connected, then the green LED will be on
(standby mode). In case of an
unsatisfactory connection, unplug the
charger from the power outlet and clean its
connector with a dry cloth.
5. The charging time depends on the battery
status. The charging time is approximately 2
hours for a 11.4 Ah/36 V battery and
approximately 4.5 hours for a 24.8 Ah/36 V
battery.
6. As soon as the battery is fully charged, the green
LED will light up continuously. Now first remove
the charging connector from the battery.
7. Then remove the charger's plug from the power
outlet.
8. Place the battery back into the holder on the
bicycle and lock the battery. Optionally, the
battery can also be charged directly in the
holder.
Version 23.05
23/59