Enable Or Disable The Watchdog Function - Ahlborn ALMEMO 500 Supplementary Instructions Manual

5 How to use the RTA6 Slide-in Module
➢ The control of the analog output via the interface is only possible in the
Transparent Mode (see Supplementary Instruction Manual ALMEMO
Transparent Mode).

5.6 Enable or disable the Watchdog Function

If the Watchdog function is enabled, all relays will drop out and all
analog outputs will transmit 0 V respectively 0 mA in case the control
of the data logger or the control of controlled relays or analog outputs
via the interface fails for one minute.
The Watchdog can be enabled for every RTA6-Einschub individually.
Enable the Watchdog function
1. In the Home screen of the app, tap on the button
2. Tap on device list.
3. Tap on the arrow
4. Tap on the arrow
5. Tap on the arrow
want to enable the Watchdog function.
6. Tick the checkbox next to Watchdog.
➢ The Watchdog function is enabled.
➢ In the line Watchdog Status "OK "will be displayed as long as the control
actions via interface or via measuring circuit board can be received at least
once per minute.
➢ All relays will drop out and all analog outputs will transmit 0 V respectively
0 mA in case the control of the data logger or the control of controlled relays
and / or analog outputs via the interface fails for one minute.
➢ In the line Watchdog Status ERROR will be displayed and the Watchdog
LED of the RTA6 slide-in module will light in case the control of the data
logger of the control of controlled relays via the interface fails for one minute.
The Watchdog Status ERROR will be displayed until the function has been
disabled and been enabled again (if required).
- 20 –
>
in the line of a measuring circuit board.
>
in the line output module.
>
in the line of the RTA6 slide-in module, in which you
®
.
500