Remove Rta6 Slide-In Module From The Housing Of The Data Logger - Ahlborn ALMEMO 500 Supplementary Instructions Manual

Disable Watchdog Function
→ Follow the steps 1 to 4 of the section Enable Watchdog Function.
→ Untick the checkbox next to Watchdog.
➢ The Watchdog function is disabled.
➢ The line Watchdog Status will no longer be visible.
5.7 Remove RTA6 Slide-in Module from the Housing of
the Data Logger
! The data logger must be switched off.
! The data logger must be disconnected from the power supply.
1. Loosen the knurled screws that hold the RTA6 slide-in module in place.
2. Remove the RTA6 slide-in module from the housing of the data logger.
Make sure that no short circuits on the circuit board occur. Never
place any conducting parts (e.g. screwdriver) on the circuit board.
Short circuits will result in product damage.
Protect the module against electric discharge. Only operate the
module in electrostatic protected areas.
5 How to use the RTA6 Slide-in Module
- 21 –