Table of Contents
Advertisement
Itamar Medical Ltd.
3.2
Sleep Test
You can start the home sleep test once all setup activities are completed successfully and
you are in bed and ready to go to sleep. The Application will confirm that all the sleep test
preconditions have been properly met and a START button will be displayed.
Press the START button and go to sleep. The data is recorded throughout the night and stored
in a remote Web Server.
NOTE:
If you need to get up during the night, there is no need to carry around the Mobile
phone. Yet, do not remove the WatchPAT device or sensors.
3.3
Test End
In the morning an END RECORDING button will be displayed on the Application screen. Press
the END RECORDING button and the recording will stop. At this stage you should take off the
device from your arm, finger and chest (if exists). The last of the recording data still needs to be
transmitted from the device so keep the device in proximity of the phone and before you close
the Application wait for the Application's confirmation of the completion of the test.
If you are using the WPONE-M option, you can reuse the device for the same patient with
a new probe, chest sensor sticker and battery for every additional night before disposing,
otherwise dispose after first night.
Follow the local, state, national governing ordinances and recycling instructions regarding
disposal or recycling of the device and device components, including batteries.
NOTE:
The battery is most likely still functional after the full night sleep test, so you may
consider using it in another appliance, before disposing of it.
WatchPAT™ONE System
24
Operation Manual
Advertisement
Table of Contents
