Itamar Medical OM2196470 Operation Manual page 23

Itamar Medical Ltd.

NOTE:
You may need some assistance putting on the WatchPAT device. If needed have
someone present to assist you.
3.1.1 Application Installation
Find the WatchPAT™ONE Application at the mobile application stores and have it installed on
your Mobile phone. Follow all instructions that your phone presents during the installation
process, until the Application has been successfully installed. It will request access to files, so
it can keep the recording files, and access to location because this is a precondition for using
the Bluetooth communication.
It is preferred to install the Application in advance so when bed time arrives the Application
will be ready to go.
3.1.2 Application Setup
The wrist device that will be applied on your hand will transmit the recorded data to your
mobile phone's Application. Place the mobile phone in proximity to the device, so the two
can easily communicate. It is strongly recommended to place it in the room you sleep in, not
exceeding five meters in between.
WARNING
Use your mobile phone vendor recommendation for safe distance location of the
phone.
Note that the Application runs on your mobile phone all night long. To prevent battery
depletion during the home sleep test, do connect your phone to its charger during the night.
At bed time, and before running the Application, insert a AAA Alkaline battery into the battery
compartment of the WatchPAT device (see Figure 4 – Battery insertion).
Next, run the WatchPAT Application on your Mobile phone and follow its instructions, it will
lead you throughout the setup stage and into the test.
During the setup process you will be requested to input a personal identification number
(PIN). This number is personal and will be provided to you when the WatchPAT product is
assigned to you. It will always be a number that you are familiar with.
WatchPAT™ONE System 22 Operation Manual