Table of Contents
Advertisement
7 Adding an iServer 2 to Omega Enterprise Gateway (OEG)
iServer 2 devices can be added to Omega Enterprise Gateway 2.4 (OEG) in a non-internet
environment by adding the iServer 2 to OEG as a device. An active OEG license and access to a
Windows 7, 8, 9, or 10 OS PC is required to download and run OEG. OEG can be purchased and
downloaded from the following link:
There are two methods to connect the iServer 2 to OEG. The first method requires the iServer 2 to be
set to the default DHCP network setting and requires access to a DHCP-enabled router with an open
port and an RJ45 Ethernet cable. The second method requires Administrator access to the Windows
OS PC running OEG and requires the iServer 2 to be set to the Static IP network setting and the iServer
2 unit to be plugged in directly to the Windows PC.
7.1 Method 1: DHCP Router Method
To add an iServer 2 to OEG using the DHCP router method, begin by ensuring the iServer 2 is set to
the default DHCP network settings ( 6.2.1 Network Configuration ) and follow the steps below.
Step 1: Connect the iServer 2 unit to a DHCP-enabled router using an RJ45 Ethernet cable.
Step 2: Ensure the Windows PC that will run OEG is on the same network as the connected iServer
2.
Step 3: Launch and log in to your OEG account.
Step 4: Click the
and click TC or Probe from the Product Model dropdown, depending on the model of
iServer 2 being connected.
https://www.omega.com/en-us/oeg
icon or Add Devices . Then select iServer 2 from the Product Family dropdown
Figure 45: OEG Add Devices menu – iServer 2 Model
33 |
M 5 7 9 1
Advertisement
Table of Contents
