Table of Contents
Advertisement
6.2 Network
To manually change the IP Address, Netmask, and Gateway address of the iServer 2, the user must
click the primary Network Tab from the main iServer 2 web UI page.
Click the Static bubble as shown in section 6.2.1 Network Configuration to enable the manual
configuration of the IP Address, Netmask, and Gateway addresses.
6.2.1
Network Configuration
Clicking the Network tab of the iServer 2 web UI provides a window to configure IP
parameters and Ethernet interface options.
•
DHCP – If the DHCP bubble is selected, the iServer 2 will dynamically request an IP address, a
subnet mask, a gateway address, and a DNS address from the DHCP server. The DHCP option
is enabled by default.
•
Static – If the Static bubble is selected, the user will be able to configure the IP Address,
Netmask, and Gateway address for the iServer 2 manually.
•
IP Address – This indicates the IP address of the iServer. When DHCP is enabled, this field will
be dimmed. When Static is enabled, the IP Address can be changed.
•
Netmask – A 32-bit number that is used to distinguish the network and host portions of the IP
address. The iServer 2 default Netmask is 255.255.255.0 When DHCP is enabled, this field will
be dimmed. When Static is enabled, the IP Address can be changed.
Figure 32: iServer 2 web UI Network tab
Figure 33: DHCP/Static network configuration window
21 |
M 5 7 9 1
Advertisement
Table of Contents
