Powering The Iserver 2; Led Status Indicator - Omega iServer 2 Series User Manual

4.4 Powering the iServer 2

All iServer 2 variants come with a DC power supply, international power supply adapters, and a 9 V
battery. Models that offer Power over Ethernet can be powered with a network switch that supports
PoE or a PoE injector (sold separately). Once the device is powered on, fully booted up, and the
appropriate sensor is connected, readings will appear on the display. To power the iServer 2 using
the DC power supply, plug in the power supply to the DC 12 V port located on the iServer 2. For
instructions on how to power the iServer 2 through the Power over Ethernet feature, refer to section
4.4.3 Power Over Ethernet.
4.4.1

LED Status Indicator

Refer to the following LED Status Indicator table to identify the different iServer 2 behaviors
and statuses.
LED Color
OFF
Red
(Blinking)
Red (Solid)
Green
(Solid)
Green
(Blinking)
Amber
(Solid)
Figure 11: LED Status Indicator
Status
No Power
System Boot
Factory Reset
Internet Connection
Detected
Firmware Updating
No Internet Connection
Detected
Description
No power applied.
System rebooting.
Press and hold the reset button for 10
seconds to reset the iServer 2 to factory
default.
WARNING: The factory reset will reset all
stored data and configuration.
iServer 2 is connected to the Internet.
Firmware update in progress.
WARNING: Do not unplug power while
update is in progress.
iServer 2 is not connected to the Internet.
11 | M 5 7 9 1