Xerox AltaLink C8130 Series User Manual page 347

C O P Y A N D S C A N P R OB L E M S
Your printer is designed to produce consistently high-quality scans and copies. If you observe quality problems, use
the information in this section to troubleshoot the problem. For more information, go to
ALC81XXsupport.
C C a a u u t t i i o o n n : :
The Xerox Warranty or Service Agreement does not cover damage caused by using
unsupported paper or specialty media. For more information, contact your local Xerox representative.
Copy and Scan Problems and Solutions
If the copy or scan quality is poor, refer to the following table:
S S Y Y M M P P T T O O M M S S
Lines or streaks only present in copies made from the
document feeder.
Spots present in copies made from the document glass. There is debris on the document glass. When scanning,
The reverse side of the original document shows on the
copy or scan.
The image is too light or too dark.
Colors are inaccurate.
If the problem persists, for online support information, go to www.xerox.com/office/ALC81XXsupport.
Performing the Copy Calibration Procedure
To optimize copy job quality, perform the Copy Calibration procedure.
1. At the printer control panel, press the H H o o m m e e button.
2. Touch D D e e v v i i c c e e .
3. Touch T T o o o o l l s s .
4. Touch T T r r o o u u b b l l e e s s h h o o o o t t i i n n g g > > C C a a l l i i b b r r a a t t i i o o n n > > C C o o p p y y C C a a l l i i b b r r a a t t i i o o n n > > N N e e x x t t .
5. To run the Copy Calibration procedure, follow the onscreen instructions.
Xerox ® AltaLink ® C8130/C8135/C8145/C8155/C8170 Series Color Multifunction Printer User Guide
S S O O L L U U T T I I O O N N S S
There is debris on the document glass. During
scanning, the paper from the document feeder passes
over the debris, which creates lines or streaks. Clean all
glass surfaces with a lint-free cloth.
the debris creates a spot on the image. Clean all glass
surfaces with a lint-free cloth.
Enable Background Suppression.
Adjust the Lighten/Darken or Contrast settings.
Copy: Adjust the Color Balance settings.
Scan: Verify that the correct Original Type is set.
Troubleshooting
www.xerox.com/office/
347